Why pipes burst in Fordham buildings
Much of Fordham was built before 1930, and walk-up apartment buildings are the most common housing in ZIP 10458. The plumbing in many of these buildings is decades old, and some of it is original. The usual failures we see:
- Risers and supply lines that corrode from the inside, especially older galvanized steel.
- Cast-iron waste stacks that crack with age.
- Frozen pipes along outside walls when the heat goes out in a cold snap. They usually split while frozen and leak when they thaw. See frozen pipe water damage.
- Fittings and supply hoses under sinks, toilets and washing machines.
- Repairs and renovations next door that disturb old pipes.
Why one burst pipe becomes a building problem
In a building where apartments are stacked on top of each other, water follows gravity. A riser that lets go on the fifth floor can send water through the ceilings and walls of every apartment below it and into the cellar. That's why, on a burst-pipe call, we check every unit below the source, not just the one that called.
What we do on a burst pipe job
- Confirm the water is off and the source is isolated. The repair itself is a plumber's job; we can work alongside the building's plumber.
- Extract standing water from floors, carpet and the units below.
- Map the moisture. Thermal imaging and moisture meters show how far water traveled inside walls, ceilings and floors.
- Check the ceilings. A soaked plaster ceiling can sag and fall. We check it before anyone works under it.
- Dry in place where possible. Burst-pipe water is usually clean (Category 1) if it's caught quickly, so more can be dried without tearing out. We use cavity drying for walls and ceilings when the readings allow it.
- Verify and document with daily readings and a drying report.
Is burst pipe water clean?
Water from a supply pipe starts out clean. But it doesn't stay that way: after it sits for a day or two, or soaks through building materials and dust, it can degrade to Category 2. Water from a drain line or waste stack is contaminated from the start. That's one more reason to start extraction quickly.
Do you fix the pipe?
The pipe repair belongs to a licensed plumber. In rentals, plumbing repairs are the landlord's responsibility. We handle the water and the drying, and coordinate with whoever is doing the repair.
Does insurance cover a burst pipe?
A sudden and accidental burst is often covered by property policies. A slow leak that went on for weeks often isn't. Damage from a pipe that froze because a building was left unheated can be handled differently depending on the policy. In a rental, the building repair is generally on the landlord; your belongings are on you or your renters insurance. More in the who-pays guide.